Main Page Sitemap

Westinghouse ceiling fan wiring manual


The white wire is the wiring neutral for the fixture and the green is the ground.
The source neutral is spliced through to the white wire on the fan.In these cases, it should be wrapped manual with black electrical tape or otherwise marked to identify it as hot.Connect the black wire from the fan to the hot (black) lead from the house wiring.The ground wire is spliced to the source ground and to any outlet box terminal using a westinghouse pigtail.The hot source is spliced to each controlling device and the output of the controllers ceiling are connected at the fan splicing black to black, white to white, and the ground connecting to the terminal on the fan box.From the switches, 3-wire cable runs to the ceiling outlet box.The red wire is spliced to the output on the dimmer and at the other end wiring to the blue light wire.Open it, pop the plug out of one of the wire holes and thread a wire clamp westinghouse into.The hot source is spliced to the black fan wire and the black wire running to the dimmer.The traveler wires are spliced together in the ceiling fixture box to run between switches.If the fan has a light the red/blue/striped wire would also be connected to the hot lead from the house.The red wire on the 3-wire cable is connected to the switch and at the fan, it's manual spliced with the blue wire to the light.In this arrangement a light fixture and exhaust fan are wired to the same source. Three-wire cable runs from there to the controllers on the wall.
Use this wiring when the power source originates at the wall manual box and manual you want to control both the fan and light secret with a single switch.
The instruction white wire is no longer used for hot and instead, the source neutral is run through to the switch box to satisfy the 2011 wiring NEC requirement.
These should be capped at both ends with a wire nut.
This is the updated wiring for this arrangement with a 2-wire cable added between the fan/light and switches.
Some newer homes come pre-wired for fan-light combinations, and offer two separate wall switches: one for the light, and one for the fan.
The travelers do not connect to the fan or light.
Splice the black secret and white cable wires to the fan wires using a wire nut.Note that if you encounter a white wire with a marking piece of colored tape attached, this could be used to signifiy it is being used as something other than a neutral.Wire the source ground to the ground wires for the switch and the fan.More Like This.Spice the second to the black final cable wire running to the fan.The wiring of said kits can vary by case, so consult the included manual.Some older houses may not have a separate ground lead and use the metal conduit and electrical boxes as ground.Is there an additional wire, presumably a black or a red?The green wire is ground for the entire assembly.The source is wired directly to the fan and also spliced through to the switch.




Sitemap