Main Page Sitemap

Oreck xl air filter manual


oreck xl air filter manual

Wipe the filter outside of manual the cleaner with a damp cloth.
Do not oreck let the unit run manual while in any one stationary position for any period of time.
Use only manual manufacturers recommended attachments.
Press on edges filter of bag collar to ensure bag is oreck completely installed.When rotating, both bearings must be in the "OLD" position.Replacing Motor Filter and Oreck Fresh Air.The Scent Disk should be replaced every month when changing the inner filter bag.Page 4, parts List, Assembly, Operating Instructions, General Information.Page 7, oreck maintenance and Customer Service, your Oreck vacuum cleaner is a product of precise engineering.Do not use without filter bag assembly in place. Pinch power cord manual together and slide annivarsy approxi- mately 1-2 inches through the annivarsy bottom annivarsy hole in flat side of cord strain relief.
Page 3, accessories, Warranty, Troubleshooting Guide.
This light-colored pocket is located inside the outer cloth bag in the area where the paper filter dust bag attaches to the intake tube.
Keep the unit moving while in operation.
Save these instructions Household Use Only.
Do not use with damaged cord or plug.To unplug, grasp the plug, not the cord.7 Remove manual the replacement belt from the storage channel.Using an Oreck Fresh Air, your oreck XL21 vacuum cleaner has a special oreck fresh AIR.Clamp until the power cord is tightly rested under clamp.Unmatched settings will cause damage to your machine.Note: The bearing assembly setting marked "OLD" has no ribs nascar on the top of the assembly.Edge Brush Replacement, Motor Filter and Oreck Fresh Air.To attach the power cord to the cord strain relief, logic grasp the power cord approximately 12 inches from the base of the handle.Do not pull or carry by cord, use cord as a handle, close door on cord, or pull cord around sharp edges or corners.Do not allow to be used as a toy.Use extra care when cleaning on stairs.How to Replace a Worn Belt warning: Unplug cord from electrical outlet before servicing.Pull burned out bulb from holder and replace with new bulb.


Sitemap